Description
6R100, 6R80 Oversized Pressure Regulator Valve Kit, 2015-Up, Sonnax 95740-46K.
Fits ’15-later 6R80 units.
Tooling:
- F-95740-TL
- VB-FIX
Wear is commonly found at different areas in Ford 6R80 pressure regulator bores. If a worn sleeve end causes high line pressure, leading to broken drums, pistons, or other parts, as well as restricted converter/lubrication flow, then the sleeve end is wearing down the components and obstructing the converter’s lubrication system. Wear at the spring end of the bore allows low line pressure and lube/TC fluid to exhaust leading to a burned converter clutch and premature bushing failure. Sonnax oversized pressure regulator valve kit 95740-46K restores valve-to-bore or sleeve clearances so the pressure regulator valve can maintain correct pressures.
- Hardcoat anodized aluminum valve combats premature wear
- Alloy aluminum sleeve is significantly more wear-resistant than the OE sleeve
- Valve
- Sleeve
Symptoms:
- Poor shift quality
- Flare shifts
- Harsh shifts
- Erratic line pressure
- Slips in Forward & Reverse
- Delayed Reverse
- No Reverse
- TCC slip
Cause:
Excess valve and bore clearance allows critical line pressure to exhaust causing high or low pressure depending on the location of the wear.
Correction:
Sonnax oversized valve and tool kits restore the correct valve/bore clearances and line pressure control as well as prevent future wear in this area.
Warning:
Verify OE valve and sleeve measurements before use.
There are some small diameter and length differences that can cause fit and pressure issues if mismatched into the wrong application.