Description
46RE / 47RE / 48RE TransGo Reprogramming Kit, 1996-On, TFRE-PRO.
This kit is great for extreme duty work trucks and performance modified trucks!
(Electronic Governor Units Only)
This TFRE-PRO Reprogramming Kit fits 1995 and newer Dodge and RAM vehicles equipped with the 46RE / 47RE / 48RE automatic transmissions. Does not fit 1995-type valve bodies without the 3/16 checkball in lower channel casting.
Common complaints on this transmission include:
- TCC slip or shudder
- 2nd gear band and direct clutch failure
- torque converter drain-back
Corrects / Prevents / Reduces:
- TCC slip or shudder
- Reduces converter drain-back
- Soft shifts
- 2nd band failure
- 3rd clutch failure
- 2-3 shift overlap
- Increases clutch element torque capacity
- Improves TCC engagement feel
- Provides full control of TCC apply in 2nd, 3rd, 4th as well as optional 1st gear lock-up
- Provides short clean shifts
Includes:
- (3) High-temp low shrink sealing rings
- Lower 1-2 accumulator spring
- Front servo washer and optional spring (for oversized aftermarket servo)
- Rear servo optional springs, tapered spring and spacer
- Drill-guide plate, drill bit and drill-stop spacer to modify the valve body casting
- Boost valve bracket
- Drop-in repair detent repair bullet, spring and Mumbly peg (for easy detent spring and bullet installation)
- USA-made hardened steel manual valve with converter charge in park provision and cherry bomb
- Drop-in USA-made hardened TV valve, boost plug and tapered spring
- Part throttle body transfer plate, pin, spacer and detent limit valve spring
- Drop-in USA-made hardened steel throttle valve and spring
- Patent-pending triple valve body separator plates
- (4) Longer screws and washers for the hold down plate
- 3-4 quick fill valve springs (whites for Diesel engine, orange for gas)
- (3) 3-4 accumulator springs, vented accumulator cover, and plug for accumulator housing
- Transfer plate, tapered plug, spring, checkball, limit bushing and O-ring
- Solenoid body plate
- Lower valve body separator plate
- PR valve shim, spring seat and inner spring for line-to-converter feed provision as well as outer spring for increased pressure
- (3) Drill bits
