Raybestos #RCPBP-40 4R100 Blue Plate Clutch Module 1998-Up. Upgrades Available Here

$ 359.00

Add Kolene Steel Module STMFORD07K ? *

Add OE Steel Module #653 ? *

Add Overhaul Kit 36002EBW ? *

Description

Raybestos #RCPBP-40 4R100 Blue Plate Clutch Module 1998-Up


 

Hi-Static Friction Clutch Plates

Question: I recently purchased a gen2™ Blue Plate Special® Clutch-Pack® Module for a 4L60E transmission. I noticed the Low / Reverse and the Reverse Input clutches are tan colored while the rest are blue. Why would Raybestos® put these tan frictions be in a Hi-Performance friction module?

Answer: A clutch or band which is applied when going from Park or Neutral to a forward or reverse gear is considered “statically” applied. In the 4L60E the Low / Reverse clutch and the Reverse Input clutch are statically held clutches because they engage while the vehicle is at a stop. A clutch, such as the 3-4, that is applied during a shift is considered “dynamically” applied.

The color of the friction plates result from the materials and resins used in the manufacturing process. The “tan” colored friction plates we use in the gen2™ Blue Plate Special® Clutch-Pack® Module for the Low / Reverse and the Reverse Input clutches are a “Hi-Static” friction material. This is a different material than the conventional tan materials used in OE type applications. An easy test for you to do is to take 2 OE replacement Raybestos® friction plates, such as the GM 4L80E – Overrun, and squeeze them together (don’t use a steel plate). While squeezing the friction plates together, try to rub them together. The trick is to keep a clamping force while also exerting a sliding motion to push one plate in one direction and the other in the opposite direction. Now do the same with a Raybestos® Chrysler A500/518/618 – Overdrive Direct “Hi-Static” friction plate which is similar in size. Notice the difference? I found the test results are better when the frictions have been pre-soaked but not dripping wet (patted dry). This generic test does not provide scientific data like our test equipment does, but it gets the point across.

When horsepower and torque levels exceed the factory specs, or a transbrake is used, the “Hi-Static” (high holding) material will absorb more power before it breaks away (slips) than a typical conventional “tan” friction material. These “statically” held components are not used during an up-shift and do not require the more exotic materials and processing of the gen2™ Blue Plate Specials®. So even though they look like any other TAN plate, they are much more than that.

 

Additional information

Weight8 lbs
Dimensions16 × 16 × 3 in