* K65M, 1965 to 1973 Mustang AOD Conversion Kit, AOD Throttle Valve Cable Adjustment Instructions

$ 615.00

Carburetor ? *

Motor ? *

Year ? *

Tire Height ? *

Rear End Ratio ? *

Speedometer Drive Gear Currently in Transmission/ New build *

Speedometer Driven Gear Needed ? *

Add Pigtail? (RFW PG-057, AODPT) *

4 wire AOD pigtail

Add Neutral Safety Switch? (CC A56410A, AODNSS) *

AOD A4LD NEUTRAL SAFETY SWITCH (4-PRONG)

SKU: 1965 - 1973 Mustang AOD Conversion Kit, Categories: , , , Tags: , , ,

Description

Deluxe AOD Installation Kit for 1965 to 1973 Mustangs

#K65M. You get the AOD to early Mustang crossmember, Lokar throttle valve cable, correct speedometer driven gear, correct flywheel, dip stick, shift lever kit, carburetor adapter for Holley or Edelbrock, transmission mount, block plate, inspection plate and four torque converter nuts.

You can add to or remove from this kit as needed. An AOD with a 10 1/4″ tail housing is only 1/4″ longer than an early Mustang C4 therefore you should be able to reuse your old driveshaft and yoke. The $4.00 per gallon gas will feel like $2.80 per gallon gas with an overdrive conversion.

 

Notice the Holley adapter on the carburetor and the helper return spring on the throttle valve bottom lever. On a stock AOD the correct pressure adjustment usually is minimum throttle valve cable pull at minimum throttle opening (idle) and on an AOD with a Shift Kit installed the correct setting usually is full cable pull at full throttle. If you have a Holley or Edelbrock you must have an adapter installed.

Additional information

Weight 25 lbs
Dimensions 20 × 16 × 9 in